SYMPTOM
POSSIBLE PROBLEMS SERVICE
Power/Exhaust Stage of Operation
Returning/Purging Stage of Operation
If the GypFast tool will not operate after following the above service directions,
return the tool to an Ramset Distributor Sales Representative for service.
800-241-5640
www.ramset.com
— Battery is discharged .
— Fuel Cell is low .
— There may be loss of seal
in combustion chamber .
— Fastener strip may be
binding .
— Jammed fastener .
— Fuel Cell is low .
— Spark Plug wire is loose .
— Filter element is dirty,
causing tool to overheat .
— Tool Sleeve or O-Rings
are dirty .
— Tool operates properly,
but fasteners do not
drive fully .
— Tool operates, but no
fastener is driven .
— Tool operates erratically
or appears to be
losing power—tool
LED is green .
— Charge Battery .
— Check Fuel Cell according to Operating Manual
and replace as required .
— Press Safety Yokes against workpiece for one
minute . Pull trigger . If fastener does not drive,
there is a leak that requires service .
— Use only fasteners meeting Ramset specifications .
— Clear jam according to Operating Manual .
— Check Fuel Cell according to Operating Manual .
— Contact Ramset Distributor Sales Representative
for Service .
— Remove Filter element and clean according
to Operating Manual . Use safe cleaning solution
to remove stubborn debris .
— Clean tool per Cleaning Procedure .
TROUBLESHOOTING
16
TROUBLESHOOTING
— Tool operated and
drove fastener, but
piston did not return
to start position .
— Tool does not open
after tool cycles .
— Built-up dirt and debris on
Piston or in Nose bore .
— Mushrooming of Piston Tip .
— Exhaust ports on the
Sleeve are dirty or clogged .
— Tool (Sleeve) or O-Rings
are dirty .
— Tool is dirty .
— Clean Piston and Nose bore with safety solvent .
— Contact Ramset Distributor Sales Representative
for service .
— Return tool to Authorized Ramset Distributor Sales
Representative for service .
— Contact Ramset Sales Representative for service
— Clean tool or replace Work Contacting Element
as required .
