36
If you have not run out of room by now you will have one music file which
may be played and saved as normal.
Using the sequencer
One of the uses of the sequencer in the SYNTHESISER Module is to create
the right sounds for a piece of music after the notes have been entered. You
will have already chosen or designed a sound set for use with a tune but
you might want to experiment further once the tune is in. If you only want
one particular sound per voice, then use the same envelope number for all
notes in each voice, e.g. voice 1 can use envelope 3 and voice 2, envelope
9. Use the macro facilities if necessary.
If your musical composition is more complex you can divide each voice into
loop sections by inserting loop markers (
|
) and assign a particular envelope
number for each loop section. You can still play the whole voice by leaving
Section
off. Keep a note of the envelope numbers so that you know which
envelopes to change in the SYNTHESISER when the sequencer is running.
Each loop section can be dialled up (and played) individually for each voice
in the sequencer until the sounds are right. Turn
Section
off, leave the voice
envelope blank and the tune will play back just as it would in the EDITOR.
You can save the music file (together with the sound set) from the SYN-
THESISER.
