mod. BIBULLDOG ADV
© Raimondi S.p.a.
machines & tools for the tile & stone professional
Chapter 5
Maintenance interventions
Page 30/44-5
5.3 Sliding device replacement
In case the sliding guides wear out, comply with the following:
TO CARRY OUT THIS OPERATION, WEAR THE PROTECTIVE GLOVES AND ACCIDENT-PREVENTION
SHOES.
Unscrew all the (
A
) (
A1
) and (
A2
) screws. Remove the guides (
B
) (
C
) (
D
). Clean thoroughly the machine surfaces.
Position the new guide (
B
), push it towards the tool and tighten the screws, but not completely (
A1
). Place the new guide (
C
)
so that it adheres to the surface and fix it, clamping the screws completely (
A
). Then position the guide (
D
) and tighten the
screws, but not firmly (
A2
).
A
A2
D
B
A1
A1
D
B
A
C
C
A2
5.3.1 Adjusting the sliding device
If you notice that the carriage features excessive clearance, proceed as follows:
TO CARRY OUT THIS OPERATION, WEAR THE PROTECTIVE GLOVES AND ACCIDENT-PREVENTION
SHOES.
Insert the trolley (
A
) on the guides. Position the striker (
E
) on the trolley surface and after checking it is leaning on the guide
(
C
) tighten it with the clamps (
F
). Make the trolley slide and perfect the guide position (
B
) so that the striker (
E
) keeps touching
the guide (
C
). Once the right position is found, firmly tighten the screws (
A1
), the ones at the guide end first and then the
central two. Push the guide (
D
) towards the trolley edge, leaving room (0,5 mm / 0,02 inches) between the guide and the trolley
edge. Firmly tighten the screws (
A2
), the ones on the guide end first and then the central two. Check the correct assembly by
making the trolley slide completely (
A
). If the trolley doesn’t slide properly, slightly slacken the screws (
A2
) and repeat the
above-described operations.
A
C
A1
D
B
C
A2
GUIDE ADJUSTMENTS MUST BE MADE ON THE EXTERNAL GUIDE ONLY.
E
F
F
B
A2
