mod. BIBULLDOG ADV
© Raimondi S.p.a.
machines & tools for the tile & stone professional
Chapter 4
Use of the commands
Page 22/44-4
WHEN SHAPING, BEAR IN MIND THE INSTRUCTIONS GIVEN IN THE “
WORKSTATION
PARAGRAPH”
(see
paragraph 2.6).
BEFORE PROFILING, MAKE SURE THAT THE GRINDING WHEEL IS SHARP, PLACED IN THE CORRECT
POSITION AND THAT THE MATERIAL HAS BEEN PROPERLY BLOCKED.
BEFORE PROFILING, MAKE SURE THE KNOB AND THE HANDLE ON THE TROLLEY HAVE BEEN PROPERLY
FIXED.
THE FEEDING SPEED DURING THE PROFILING SHALL BE PROPORTIONAL TO THE HARDNESS AND
THICKNESS OF THE MATERIAL TO BE PROFILED TO PREVENT THE MATERIAL FROM DISPLACING AND
TO AVOID A MOTOR OVERLOAD.
IF THE PROFILING PERFORMANCE IS UNSATISFACTORY , DESPITE THE COMPLIANCE WITH ALL THE ABOVE-LISTED
PROCEDURES, IT IS NECESSARY TO CHECK THE CLAMPS TIGHTNESS AND TO DRESS THE GRINDING WHEEL BY
MEANS OF THE DRESSING STONE.
AFTER YOUR WORK AND BEFORE DISENGAGING THE PIECE FROM THE CLAMPS, TURN OFF THE MACHINE
BY MEANS OF THE POWER SWITCH.
AN EXCESSIVE LOCKING DEVICE PRESSURE MAY CAUSE THE DEFORMATION OF THE TROLLEY AND
JEOPARDIZE THE SLIDING MOVEMENT.
4.4 Comply with the following warnings for all profiling types
