Raider 40, Инструкция по сборке

Страница: 67 / 80

-58-
Raider 40 Manual Military version
3.20 Fuel Hose
FUEL HOSE AND PRIMER
Separate fuel tanks are connected to the engines by a hose with a primer bulb. The primer bulb forces
fuel into the Multi-fuel (Throttle Body) Atomizer float chamber for engine starting. Check valves on each
side of the primer bulb maintain fuel flow, in one direction only, from the tank to the engine.
Disassembly
1. Remove and discard hose clamps (1) and primer bulb clamps (2) as required.
2. Remove tank connector (3) and hose (4) .
3. Remove engine connector (5) and hose (6) .
4. Remove primer bulb assembly (7) . Remove check valves (8) and (9) from primer bulb (10) .
NOTE
Note direction of fuel flow as indicated by the arrow on the primer bulb.
Cleaning and Inspection
1. Clean components using soap and water.
2. Dry all components with low pressure compressed air. Make sure all parts and passages are
completely dry.
in-Line Fuel Filter Replacement
NOTE:
In-line fuel filters cannot be serviced. Replace in-line fuel filters once a year or with each
tune-up. When replacing an in-line fuel filter, note direction of fuel flow as indicated by the arrow on the
filter housing for proper installation.
1. Loosen clips (1) on each side of the filter (2) and slide down the hose.
2. Separate the fuel filter from the hoses and discard.
3. Replace with new fuel filter.
4. Attach hoses and secure clips.
Fuel: Gasoline; Avgas; JP-5; JP-8; Diesel #2
Note:
To comply with local EPA requirements when JP-5 or JP-8 fuels are used Raider Additive
Must be added to reduce smoke and emissions.
1. Clamp P/N
2. Clamps P/N
3. Fuel Connector – Bladder P/N 9999800MA2
4. Hose – P/N
5. Fuel Connector – Engine P/N 3B2702501M
6. Hose – P/N
7. Primer Bulb – P/N
8. Connector
9. Connector
10. Primer Bulb P/N
11. System P/N 3E070-2001M