Raider 40, Инструкция по сборке

Страница: 56 / 80

-
45 -
Raider 40 Manual Military version
Gear Case/Propeller
Ref. No. Part No. Description Q’ty Remarks
15-1 345-60215-0 Bearing 32007 1
15-2 348010-1 Bevel Gear “A” 1
15-3 348-64211-0 Propeller Shaft 1
15-4 348-64215-0 Clutch 1
15-5 345-64217-0 Clutch pin 1
15-6 345-64219-0 Snap, Clutch pin 1
15-7 345-64221-0 Spring, Clutch 1
15-8 345-64222-0 Spring Holder, Clutch 1
15-9 345-64223-0 Push rod, Clutch 1
15-10 345S60101-1 Housing, Propeller Shaft 1
15-11 345-60211-0 Needle Bearing 22-30-30 1
15-12 334-60223-0 Oil Seal 22-36-10 1
15-13 9601-0-6007 Ball Bearing 6007 1
15-14 345-60103-0 “O” ring 353 -69.44 1
15-15 348-64030-0 Bevel Gear “C” 1
15-16 345-64032-0 Washer 22.1-28-3 1
15-17 9101 13-5830 Bolt 2
15-18 3C8-64231-0 Thrust Holder, Propeller 1
15-19 348W64108-0 Propeller 1 Raider Standard
15-20 348-64232-0 Stopper, Propeller 1
15-21 345-64124-0 Washer, 17-32-3 1
15-22 345-64121-0 Nut, Propeller 1
15-23 951503-0325 Split Pin 3-25 1
15-24 348-60217-0 Trim Tab 1
15-25 353-60219-0 Gasket Trim Tab 1
15-26 9101 13-5618 Bolt 1
15-27 353-64036-0 Shim 36-44-03 AR
353-64037-0 Shim 36-44-0.15 AR
353-64038-0 Shim 36-44-01 AR
Raider Outboards are equipped with seal sacrificial anodes to help protect metal parts from
the effects of galvanic corrosion (electrolysis). Disintegration of the anodes indicates they are
performing their function. Anodes must be replaced when reduced to 2/3 its original size.
Engine corrosion will increase if eroded anodes are not replaced.
The powerhead anode provides protection to the powerhead. It is located in the cylinder
head. The anode should be replaced whenever work requires removal of the cylinder head
or when a complete overhaul of the engine is performed.
The following procedure is used to test for proper installation of the anode. Make sure the
surface of the anode is clean prior to testing.
1. Calibrate an ohmmeter on the high ohms scale.
onnect one meter lead to a ground on the powerhead
and the other lead to the anode. The ohmmeter should
show a low reading. If not, remove the anode; clean the
surface where it was mounted. Install anode and retest.