Rado A100, Инструкция по эксплуатации

Страница: 5 / 20

3
Screen No.1:
Description of the screen No.1:
1.1 Assembly travel speed
Displays the actual travel speed of the seeding assembly based on the signal from the
GPS/Glonass, radar or induction sensor impulses.
In case of usage of the:
• induc on sensor , it is necessary to adjust it correctly. The distance of the M12 indu-
c on sensor from the scanning rose e must be 4 mm maximally. If the sensor is co-
rrectly adjusted, its signalling LED must light on every me the rose e metallic tooth
passes around the sensor. In case of an incorrect adjustment, some impulses are
skipped which leads to inaccurate travel speed measuring. This will cause inaccuracy
of the sown dose and reading distor on of the hectare-meter.
• radar , it is necessary to install it so it will not be a ff ected by e.g. the rota ng wheels
of the trac le machine (e.g. a tractor) or by a large cloud of dust or other solid par c-
les
fl ying o ff of the tractor wheels or the seed drill itself. This will again cause increa-
sed inaccuracy of the sowing and hectare-meter values.
• GPS/Glonass , the antenna must be installed at the highest point of the drill and must
not be shaded by any metallic cover. Unless the antenna direct visibility into the sky
is ensured, the GPS system will operate incorrectly and the drill will not react to the
movement, con ngently a non-zero speed could be measured due to the poor signal
even in case the drill is at stands ll (e.g. when parked under a hall roof).