PROGRAMMING A DEVICE
The RadioShack 8-in-One Remote is preset at the
factory to operate the following devices:
•
Motorola Cable Box
•
RCA TV,VCR, DVD Player, and
Satellite Receiver
•
Pioneer CD Player and Audio Receiver
•
Philips Tivo PVR (DVR) using the
AUX
key
To control devices other than the default brands,
perform the following steps; otherwise skip
this section:
NOTE
: To control a DVD Player/VCR Combo, perform
the instructions in “Programming A DVD Player/VCR
Combo” on page 11.
1. Turn on a desired device (e.g.,VCR or DVD
player) and, if applicable, insert media (e.g.,
cassette or disc).
NOTE
: Please read steps 2 through 9 completely
before proceeding. Before starting step 2, review
the “Manufacturer’s Codes” (starting on page 80).
Brands are listed alphabetically in order of the most
popular codes first. Highlight or write down the
devices and the codes you wish to program.
2. Press and hold
P
until the bottom IR segment
flashes twice. The program keys will appear:
NOTE
: If the display turns off due to inactivity,
the remote control will exit programming and
return to the last-selected device menu screen.
To start programming again, repeat this step.
NOTE
: To stop programming at any time, press
once to return to the program keys screen. Press
once more to exit completely.
3. Press
DEV SET
once. The
Device Setup
programming screen will appear:
4. Press a device key once (i.e.,
CBL
,
SAT
,
TV
,
DVD
,
AUD
,
VCR
,
AUX
, or
CD
). The selected device key
will animate.
NOTE
: Refer to the “Device Table” on the previous
page when choosing a device key for programming.
5. Use the
Manufacturer’s Codes
(starting on
page 80) to locate the type of device and
brand name and then use the number keys
to enter the first four-digit code for your
device. If performed correctly, the bottom
IR segment will flash twice.
NOTE
: If the bottom IR segment displays one long
flash instead, a mistake has occurred. Try entering
the same code again.
6. Aim the remote at the device and press
PWR
once. The device should turn off. If it does
not, repeat steps 5 and 6, trying each code for
your brand until you find one that works. If it
still doesn’t work, try
Searching For Your Code
on page 12.
7. If the code works, press
OK
once. The bottom
IR segment flashes twice.
10
Programming A Device
8-
IN
-O
NE
R
EMOTE
P
OWERED
B
Y
K
AMELEON
RS Kameleon 8in1 UG 7/9/03 1:02 PM Page 10