Rad Power Bikes RadRover, Руководство пользователя

Страница: 15 / 48

13
Adjusting the Seat Position and Angle
To change the angle and horizontal position of the seat:
1) Use a 6 mm Allen wrench to loosen the seat adjustment bolt (pictured at right)
underneath the seat on the clamp positioned immediately underneath the seat,
above the rear wheel.
2) Move the seat backwards or forwards in the guide and adjust the angle of the
seat. A seat position horizontal to flat ground is desirable for most riders. Do not
exceed the limit markings on the seat rail, which show the minimum and
maximum horizontal movement allowed for this component.
3) While holding the seat in the desired position, use an Allen wrench to tighten
the seat adjustment bolt securely to the recommended torque value.
NOTICE: Prior to first use, be sure to tighten the seat clamp via the seat adjustment bolt properly. A loose seat clamp or seat post
adjustment bolt can cause damage to the bike, property, loss of control, a fall, serious injury, or death. Periodically check to make
sure that the seat clamp is properly tightened.
NOTICE: Ensure seat post and seat are properly adjusted before
riding. DO NOT raise the seat post beyond the minimum insertion
marking etched into the seat post tube (as shown at right). If the
seat post projects from the frame beyond these markings (shown
far right), the seat post or frame may break, which could cause a
rider to lose control and fall. Ensure the minimum insertion
markings on the seat post are inside the seat tube of the frame
(like pictured above).