Rad Power Bikes RadRover, Руководство пользователя

Страница: 10 / 48

8
Step 4:
Inflate tires to desired PSI. Recommended pressure is 20 PSI (1.38 Bar) for the front and rear tires of the RadRover.
Recommended tire pressure is indicated on the tire sidewall. Do not overinflate or underinflate tires.
Step 5:
Install the pedals. Locate the pedal marked with an
“L” at the pedal axle end and notches on the outside of the
pedal axle (1, at right). The pedal marked “L” with notches
goes on the crank on the left side of the bike (which is the
same as a rider’s left side when riding). The left pedal is
reverse threaded and tightens counterclockwise . Carefully
thread the pedals by hand slowly. Do not cross thread or
damage the threads.
Tighten securely using a pedal wrench to avoid damage caused by wider wrenches , as shown in assembly video.
The right pedal is threaded so that it is tightened by turning clockwise , has an “R” stamped into the pedal axle end, and a
smooth exterior on the outside of the pedal axle (2, above). Carefully thread the right pedal onto the crank on the right side of
the bike (the side with the drivetrain gears) slowly and by hand. Do not cross thread or damage the threads.
Tighten securely
using a pedal wrench to avoid damage caused by wider wrenches .
Step 6:
Set desired seat height. Adjust the seat post up or down to a comfortable height,
while ensuring the seat post is inserted into the frame past the minimum insertion point.
Ensure the seat post clamp opening is centered over the gap in the seat tube and secure all
hardware and the quick release lever to lock the seat post in place so it cannot move. Do not
overtighten.