IQ3 Street Logger Dash Installation Manual
31
Gear Position Indicator Calibration (Manual Transmission only):
The gear position can be set using a calculation and then using the Datalink software while connected to a
PC. See
page 32
for programming via Datalink software.
To calibrate the gear follow the below procedure.
1.
Turn on the dash and Enter Setup 2 mode by entering a MEDIUM press on button 2
2.
The Dash will display SETUP 2?
3.
Confirm you wish to enter SETUP 2 by entering a SHORT press on button 1. The dash will now
display CALIBRATE SPEED N
4.
Enter a SHORT press on button 1. The dash will now display CALIBRATE GEARS N
5.
Enter a SHORT press on button 2 to toggle N to Y
6.
Enter a SHORT press on button 1, the dash will now display GEAR 1 and a value. This value
represents the ratio between engine RPM and Speed (not final drive ratio or gear ratio).
7.
Safely drive vehicle at a steady rate while in first gear
8.
Once at a steady speed, enter a SHORT press on button 1. This sets the value for that gear and will
advance to the next gear.
9.
Repeat the process above for each remaining gear. Program any unused gears the same value as
your highest gear.
10.
Once all gears are programmed, the last SHORT press on button 1 will save and exit.
Display Clock/Time:
Clock/Time is available for viewing anytime the IQ3 Street Logger Dash is powered on and not in any setup
modes. By default, it is displayed in the upper right area only when the button 1 is held down for a set
period of time, roughly 3 seconds. Regardless of what parameter is programmed in that upper right area,
the location of the clock cannot be changed.
To view clock
1.
At any point, in normal viewing mode, Press and hold Button 1 for THREE light blinks – LONG press
2.
As long as the button is held, the display will show the time which was set in the Setup 1
programming menu.
To set the time, see Entering Setup 1 mode section found on
page 22
.
Содержание 250-DS-IQ3SL
Страница 33: ...IQ3 Street Logger Dash Installation Manual 33 ...