Racepak 250-DS-IQ3SL, Руководство по установке, Страница: 21 / 63

IQ3 Street Logger Dash Installation Manual
21
External Programming Buttons
A variety of IQ3 Street Logger Dash display functions can be controlled, displayed or programmed
through use of two external programming buttons known as Button 1 and Button 2. This enables
the driver to make immediate changes without the necessity of connecting a PC to the dash.
Instead of mounting the programming buttons directly in the dash, Racepak provides the ability to
remote mount the two programming buttons for better driver access.
Racepak supplies (2) two buttons with the IQ3 Street Logger Dash however, the customer may
utilize their own preference of momentary contact button type. The customer must ensure, the
buttons selected, are normal open momentary switches and that they are capable of withstanding
the environment in which they will be utilized. The buttons are connected to the 34 pin AMP
connector located on the rear of the IQ3 Street Logger Dash. Refer to the IQ3 Street Logger Dash
Wiring Pinout section, for pin out instructions.
Many of the programming functions found in the following section may also be performed through
the use of the DataLink software and the user’s PC. These instructions can be found in the section
Programming Utilizing the DataLink Software section.
Button Programming Modes
Setup Mode 1 (Stationary): Utilized to program items such as screen brightness or pulses per
revolution (tach programming).
Setup Mode 2 (Moving): Utilized to program the system while the vehicle is moving and or the
engine is running. This is necessary as several settings utilize actual data taken from speed or rpm,
in order to program.
General Button Operation
(Display and Setup)
Basic programming functions of the IQ3 Street Logger Dash are accessed by using Button 1 and
Button 2. It is recommended the two programming buttons be mounted as Left and Right in
relation to the driver’s position viewing the dash. There are two programming modes available
referenced as Normal Display and Setup Mode.
Since the IQ3 Street Logger Dash only utilizes two buttons, it is necessary to allow multiple uses
for each button. In each of the modes, the length of time each button is held down, before
releasing, determines the exact result. The following instructions will refer to short, medium and
long button press lengths. This is the length of time the button is held down and the
corresponding warning light blink. The point at which the button is released determines the type
press that is accepted. As an example, releasing after the second LED warning light flash is
detected as a medium length press.
Type of Button Press Length of Time Warning Light Flash
Short Press and Release .2 Second before release One Flash Of Shift Lights
Medium Press and Release .5 Second before release Two Flashes Of Shift Lights
Long Press and Release 2 Seconds before release Three Flashes Of Shift Lights