Racelogic Ltd
Performance Mode
Page
20
Editing a Performance mode Test Range
You can configure the two speed ranges of the Accel2 and Decel screen to your own
custom tests.
If you wish to change the speed range over which performance is measured, press the
MENU
button from any of the performance mode screens and select the range you wish to
change from the ‘Performance Menu’ and press
OK
PERFORMANCE MENU
UNITS
WRITE RESULTS FILE
ACCEL RANGE 1
ACCEL RANGE 2
0-100-0 RANGE
Example: Editing ACCEL RANGE 1
1. Highlight ‘ACCEL RANGE 1’ and press
OK
2. The following screen will appear with the start speed of ACCEL RANGE 1
highlighted:
3. Whilst the START speed is highlighted use the
▲▼
buttons to change the speed.
4. Press
OK
and repeat this procedure for the END speed:
1 Foot Rollout
The DriftBox normally takes the start of a performance run at the point at which the vehicle
moves, but at drag strips the vehicle starts 1 foot behind the timing start line. You can
make the DriftBox start
all timing runs
from 1 foot by enabling this feature.
Enabling 1 Foot Rollout correction
•
Press the
MENU
button to enter the Performance Menu.
•
Highlight the 1 FOOT ROLLOUT option and press
OK
