SDC2000
26 / 40
User Manual
Rev. 1.0 - 12/04/05
[carr.]
If the encoder is pushed when in this submenu, field [BACK] begins
to blink and you will be able to move the cursor from field to field by
turning the knob in the desired direction.
Push the encoder again when a field is selected to confirm that you
wish to edit the current selection.
[BACK]
Push the encoder when this item is blinking to cancel
selection mode and go back to scrolling through display
screens by turning the knob.
[IS ON]
Push the encoder when this item is blinking to change
RDS status. You may toggle between RDS On and RDS
OFF.
level: [0069,0]
Push the encoder when this item is blinking to set RDS
signal level in peak-to-peak mVolts. The allowed setting
range is 0 to 8192 mVpp in 1 mVpp increments.
Push the encoder to confirm change and return to field
selection.
phase: [0000,0]
Push the encoder when this item is blinking to set RDS
carrier phase with respect to the 19KHz and 38 KHz
frequencies. The allowed setting range is 0 to 360.0° dB
in increments of approx. 0.2°.
Push the encoder to confirm change and return to field
selection.
[DSN 00]
Push the encoder when this item is blinking to select the Data Set
you wish to view and/or edit; there are eight Data Sets to choose
from.
NOTE: While Data Set management and storage is preset for 8
Data Sets, Data Sets 1..7 cannot be activated on all RDS's. Data
Set 0 is present on all RDS's and can be remotely configured using
any system with an SPB 490 protocol (UECP v.5.1).
[PSN 00]
Push the encoder when this item is blinking to select the Program
Service you wish to view and/or edit; there are sixteen Program
Services to choose from.
NOTE: PSN 00 is the Program Service of the broadcasting station,
whereas PSNs 01 through 15 are the Program Services of other
stations (EON).
Current software version will not transmit the data of PSNs 1 to 15.
