1. Open the front access door where the piezo-igniter is located. Remove the two screws that hold the control
panel in place, pull the control panel out towards you and install the variable speed control in the hole provided
opposite the piezo-igniter.
2. Locate the two fan mounting screws in the rear of the unit as shown in the above diagram and place the key
holes on the rear of the fan over the mounting screws and drop into position.
3. Connect the wires to the variable speed sensor and variable speed control as shown in the wiring diagram. Plug
fan cord into 110 wall outlet.
4. Turn the switch on (clockwise). NOTE: The stove must now be installed and gas line attached before
proceeding.
5. Turn the stove on. Once the sensor unit reaches operating temperature (in approximately 10 to 15 minutes) the
fan will turn on. The fan can be switched off, if desired by turning the switch fully counter-clockwise.
6. Once the fan has started to turn it may be desirable to adjust the minimum fan speed. Tilt the control panel
forward to access the rear of the variable speed switch, turn the variable speed switch to its minimum setting
(fully clockwise). Use the set screw on the side of the variable speed control to increase or decrease the
minimum fan speed. (It may be desirable to lower minimum fan speed to decrease the sound level created by
the fan.) Reinstall the control panel.
NOTE:
FOR EASE OF INSTALLATION THE FAN
KIT SHOULD BE INSTALLED BEFORE THE
STOVE IS PUT IN ITS FINAL POSITION.
AUTOMATIC ON/OFF THERMOSTAT
CONTROLLED FAN KIT
(Part #F35FK)
OPTIONAL FAN KIT INSTALLATION
Electrical Services
All optional fan kits are equipped with a 120V, 60Hz blower.
Note: All electric connections are to be made in accordance with CSA Standard C22.1 - Canadian Electrical Code part I
or with the National Electrical Code, ANSI/NFPA 70 (latest addition) and/or in accordance with local codes.
Caution:
Should this fan require servicing, the power supply must be disconnected.
WARNIING:
Label all wires
prior to disconnection when servicing
controls. Wiring errors can cause
improper and dangerous operation.
Verify proper operation and servicing.
WARNIING:
Electrical Grounding
Instructions - This appliance is equipped with
a three - pronged (grounding) plug for your
protection against shock hazard and should
be plugged directly into a properly grounded
three-prong receptacle.
WARNIING:
A qualified electrician must
connect electrical wiring to
junction outlet for built-in
installation.
Follow all
codes
.
