REPLACING OF CERAMIC
GLASS
Follow Removal of Front Door then
clean all materials from door frame.
Using a high temperature sealant
(temperature-resistant to 500°F
(260°C)) apply a bead of
approximately 1/8" to all four sides
of frame and insert glass with new
gasket. Frame should be placed on
a flat surface with a small amount of
weight pressing glass into sealant.
Let dry approximately 15 to 20
minutes. The door can be
reinstalled by reversing Steps 1,2.
GLASS REPLACEMENT
Only Robax ceramic or coated Neoceram glass may be used for replacement. It must be a minimum of 5mm thick.
REMOVAL OF FRONT DOOR
1.
Open both left and right side panels by pulling outwards from the side of the unit.
2.
Pull the latch handle towards the front of the unit. Disengage latch from mounting tabs.
3.
Hold the Door Frame in both hands and pull towards yourself.
4.
To replace the Door Frame to the unit reverse the above steps.
GENERAL GLASS INFORMATION
GLASS CLEANING
It will be necessary to clean the glass periodically. During
start-up, condensation, which is normal, forms on the
inside of the glass and causes dust, lint etc. to cling to the
glass surface. Also, initial paint curing can deposit a slight
film on the glass. It is therefore recommended that initially
the glass be cleaned two or three times with non-abrasive
common household cleansers and warm water. After that,
the glass should be cleaned two or three times a season
depending on the circumstances.
Warning and Cautions.
• Do not clean when the glass is hot.
• Do not use abrasive cleaners.
• Using a substitute glass will void all product
warranties.
• Do not strike or abuse glass. Care must be
taken to avoid breakage of the glass.
• Do not operate this fireplace without the glass
front or with a broken glass.
WARNIING:
Do not operate appliance with the glass front removed, cracked or broken. Replacement of
the glass should be done by a licensed or qualified service person.
