Place the canopy where you
like, mark the holes for the
canopy standoffs. Use a ¼”
drill bit. Place the grommets in
the holes and secure the canopy
to the helicopter using (4)
M3x14 cap head screws.
Radio Setup
General Information:
First, change your radio to 3 Point, 120 Degrees swash-plate mixing. My advice
is to read your radio manual for proper adjustment of the swash mixing. After you
have the radio gear installed, the basic guidelines for proper setup of an EMS
system is everything must be 90 Degrees and Parallel with all control sticks in
the center. After all linkages are installed and everything meets the above
requirements, you should have 0 degrees of main rotor blade pitch at center
stick. Make the necessary adjustment to complete the setup.
Pitch Curve Setup:
Complete the following steps in the Pitch Curve Menu of the Radio. In
Normal Mode make the Pitch curve the following: at Bottom-Stick,
0 to -2 Degrees; Mid-Stick, 5 to 6 Degrees, and Top-Stick, 9 to 10 Degrees.
For Stunt 1 & 2: Bottom-Stick, -9 Degrees; Mid-Stick, 0 Degrees; and
Top-Stick, 9 Degrees. Note: Stunt one; two should only be used by pilots, ready
for forward flight and aerobatics. Do not use these settings until your skill level is
ready.
