Install two 7x13x3 o-rings into the
head block. Next slide the head
spindle through the o-rings. Then slide
the head dampener spacers onto the
spindle
Each blade grip will have (2) 5x10x4R
bearings. Install the bearings into the
blade grip s. Slide each one onto the
spindle shaft. Secure the blade grips to
the spindle using (2) M3x10 cap head
screws. Place a 3x8x1 spacer under
each bolt before installing them.
Attach each hiller arm to the blade grip
using an M3x10 cap head screw. Put
the bolt through the hiller arm and put
a 3x5x1 spacer on the bolt next, and
screw it into the blade grip.
Slide the flybar through the seesaw.
