Antirotation guide pin
Washout link x 2
M3x10 Cap head screws
M3x5x1 Spacer x 2
Locate swashplate and slide it on the
main shaft first.
Next locate the washout base, arms,
links, M3x6 pivot studs, M3x10 cap
head screws, M3x5x1 spacers, and
M2x12 pan head screws. First slide an
M3x8 cap head screw through each
arm. Note which direction the screw
should go through the arm in the
picture. Slide an M3x5x1 on each bolt
and attach them to the base. Next
attach an M3x6 pivot stud to each of
the washout arms. Finally attach a
washout link to each arm with an
M2x12 pan head screw. Next slide the
washout onto the main shaft with the
protruding side going down first.
Attach the washout links to the pivot
studs on the inner ring of the
swashplate.
Slide the Antirotation guide pin on the
main shaft next. Secure it using the
M3x3 set screw. This will be adjusted
later, so snug is all this screw needs to
be for now.
