Step 1 – Linkage Rod Setup
In the following table the linkages will
be measured center to center as per
the picture. The table explains the
amount of rods you need to make and
which ball links to use on each end.
This will get the helicopter close to
finished setup, as always you will need
to make some final adjustments to
maximize the performance of your
Helicopter
Replacement Part #:
Linkage Rod Set – QC150
All Linkages available individually just
know the size
Step 1A – Shim Ball Installation
Install (8) Shim Balls using (8) M2-8
Phillips Screws. Install each Shim ball
as close to the recommended distance
for the center of the servo splice and
the center of the shim balls.
Carburetor
11.75-13mm
Throttle Servo
11.75-13mm
Swashplate
Servos
18-20mm
Rudder Servo
11.75-13mm
Rod Use
Elevator Servo
to Swashplate
# of Rods
1
Rod Size
2.3-35
Ball Link 1
Medium
Ball Link 2
Medium
Center to
Center
53mm
