13
7.3 Resetting a Device’s Wireless Settings
If you encounter an issue at any point during the wireless network setup process, you may reset the device by following
the directions below.
A.
begIn reset
Press and hold the button on the device for 8-9 seconds until you hear
3 beeps. Release button. You will hear the words “Resetting wireless
settings.”
b.
conclUde reset
Light ring will flash green once and then it will pulse red. You will hear the
words, “Ready to connect, follow quick start instructions.”
•
Device has been reset.
•
See Section 7.1 to begin set-up of a new wireless alarm network,
or Section 7.2 for adding this device to an existing alarm network.
note:
If no further steps are taken within 15 minutes of resetting the unit’s
wireless settings, a voice prompt “No devices found, not connected” will
be heard once, and the wireless function will turn off. The unit will then
perform as a stand alone alarm. See Section 7.2 for adding this device to an
existing alarm network.
Figure 7.3-A
Hold for
8-9 seconds
“Resetting
wireless
settings.”
Figure 7.3-B
“Ready to
connect, follow
Quick Start
instructions.”
