QubicaAMF Options Ball Return, Инструкция по установке, эксплуатации, обслуживанию и каталог запасных частей

Страница: 21 / 46

I
NSTALLATION
Options Ball Return Installation Manual – 612-860-010
15
Rev. Date 10/07
Figure 12, Rack to Ball Lift Attachment
8. Slide the rack assembly into place and secure it to the approach using four 3/8 x 2-
inch lag screws (810-556-420), lock washers (951-164-002), and flat washers (948-
964-142). If an electrical cable is present, route it up into the pedestal leg.
9. Cover the four openings in the base of the pedestal using the black button plugs
(248-001-509) provided.
10. Install the duplex receptacle in the opening provided on the pedestal in accordance
with local electrical codes. (Refer to Figure 10.)
11. Place a level along the length of the top rail of the ball rack (either side) and check
for level. If high at the Ball Lift end, remove one or more C-washers to achieve a
level condition. If low at the Ball Lift, add washers.
Verify that the rack is leveled correctly by placing a bowling ball with no initial speed
onto the center rails approximately mid way along the rack. The ball should move
toward the end of the rack and pick up enough speed to fall onto the side track.