QubicaAMF Options Ball Return, Инструкция по установке, эксплуатации, обслуживанию и каталог запасных частей

Страница: 18 / 46

I
NSTALLATION
Options Ball Return Installation Manual – 612-860-010
12
Rev. Date 10/07
I
NSTALLING THE
B
ASE
1. To install the base, measure 8.25” from the side plate of the ball lift towards foul line
and draw a line perpendicular to the centerline. Mark 5-3/8” as shown in figure 8 on
either side of the centerline on the line, and drill 5/16-inch pilot holes at the two
locations.
2. Position the base (252-002-130) over the cutout so the centerline of the base aligns
with the centerline you drew on the approach.
3. Ensure the base is parallel to the Ball Lift and secure the base to the approach using
2 of the 4 lag screws (810-564-480) and washers (945-867-242) provided.
4. Mark the locations for the back holes, and drill 5/16-inch pilot holes in the rear trap
door at the marked locations. Secure the base with the remaining lag screws and
washers.
5. The hood is secured to the base by tabs on the base that snap into slots on the
hood. The hood is attached to the access panel which, in turn, is held in place by a
three-way bracket that connects the ball rack, ball lift, and hood together. Wait until
after the Control Box and ball rack are installed to complete the hood installation.
I
NSTALLING THE
B
ALL
L
IFT
C
ONTROL
B
OX
1. The control box is to be installed inside the base. To
install the control box, remove the screws that
secure the cover of the control box and remove the
cover.
2. Position the control box on the base as shown in
figure 9 and fasten it with the four screws (809-849-
165) and washers (951-148-008) provided.
3. Connect the cables to the control box as indicated in
the drawing inside the control box cover. Refer to
“Connecting the Wiring” section of this manual.
4. Reinstall the control box cover.
Figure 9, Control Box Installation