QubicaAMF Options Ball Return, Инструкция по установке, эксплуатации, обслуживанию и каталог запасных частей

Страница: 12 / 46

I
NSTALLATION
Options Ball Return Installation Manual – 612-860-010
6
Rev. Date 10/07
The dimensions specified herein are for a typical installation and assume an approach
length of 16 ft. (487.7 cm) . This typical installation will result in the ball rack
overhanging the end of the approach by 30.15 inches (76.6 cm), with a 15 ball rack, and
approximately 15.65 inches (39.8 cm) with a 11 ball rack. The amount of overhang you
will obtain will be determined by the length of the approach in your bowling center. If
the approach is longer than that specified above, the overhang will be less by the same
amount. If the approach is shorter, the overhang will be more.
The minimum approach length that will accommodate a standard installation is 16
feet (487.7 cm).
This is because of the placement of the ball rack’s support pedestal,
which must be installed on the approach. If the approach is less than 16 feet in length,
or if more space is needed between the end of the ball rack and other installed
equipment, then you will have to offset the installation closer to the foul line by the
desired amount.
If the location of the Ball Lift is shifted, it may be necessary to cut
and splice the underlane ball return track to accomplish the installation.
A
PPROACH
O
PENING AND
L
IFT
I
NSTALLATION
For replacing an existing installation, remove the old ball lift and fill in and/or cut out the
approach opening, as necessary, to meet the specifications shown below.
1. Cut an opening in the approach floor 42 inches by 13.5 inches (106.7 cm x 34.3 cm)
starting 116-15/16 inches (298 cm) from the lane side of the foul line. Include the two
trap doors as shown in figure 2. Center the opening(s) over the underlane track. The
front trap door is required to retrieve the ball if it is not handled properly by the Ball
Lift.
Figure 2, Approach Opening Layout – Top View
2. If not installed earlier, attach the rail adapter plate (049-006-359), which is included
with the underlane track, to the end of the underlane track using two 1/4 lock
washers (951-148-002) and 1/4-20 x 1/2 hex screws (809-849-085) (See Figure 4).
Tighten securely.
Cutout Specifications
A 116 15/16” 298 cm
B 13.5” 34.3 cm
C 42” 106.7cm
D 13.5” 34.3 cm
E 12.5” 31.8 cm
F 12” 30.5 cm
Rear Trap
Door
End of
Approach
Foul Line
of
underlane track
D
F
B
Ball Lift
E
C
A
C
L
* See Note
* Underlayment should be cut narrower in area of the rear trap door.
Front Trap
Door