QubicaAMF Options Ball Return, Инструкция по установке, эксплуатации, обслуживанию и каталог запасных частей

Страница: 20 / 46

I
NSTALLATION
Options Ball Return Installation Manual – 612-860-010
14
Rev. Date 10/07
b. Attach the lower rack to the lower rack brace using 5/16 -18 x 1-1/4 hex screws
(809-857-205) and split lock washers (951-156-002).
4. Install the Ball Rack to Ball Lift. See Figure 11. Remove and discard the bolt in the
Ball Lift’s rack-mounting hole. The bolt is used for keeping the rubber grommet and
grommet bushing in place during shipment. Keep the lock nut and thick flat washer
for reuse.
5. Stack three C-washers (946-075-921) on top of the grommet bushing in the Ball
Lift’s rack-mounting hole and insert the Ball Rack’s mounting stud through the
washers and grommet bushing. Secure the rack assembly to the Ball Lift using the
thick flat washer and the 1/2-13 nut (removed in the previous step). See Figure 12.
6. Align the centerline of the rack assembly with that of the Ball Lift and mark the
locations for drilling the four pilot holes for securing the rack assembly to the
approach. Use the holes in the base of the pedestal as a template.
Figure 11, Assembled Ball Rack
7. Slide the rack assembly to one side and drill four 9/32-inch pilot holes on the marks
made in the previous step.
a. This is also the time to drill a hole for the power cable to the duplex receptacle on
the pedestal if that option is being installed.
Drill a hole of the appropriate
diameter in the approximate center of the hole pattern drilled in step 7.
b. Route the electrical cable from under the approach and out the hole that was
drilled in step 7a.
Brace