© Qube Engineering 2009
Qube’s AP1 LED Dash DIY Kit Supplemental Instructions Page 9
17)
Remove the two pushbutton boards
from the plastic housing. Do this by pushing
on the backside of the board with the small
screwdriver through the access holes in back
while pushing downward on the two tabs on
the bottom side of the board. Set the
boards aside.
18)
Remove the four black template pieces
from the housing. Do this by gently pushing
on them from the backside through the bulb
access holes with the eraser side of the
pencil. As each piece is removed, put it
adhesive side down on the wax paper. Set
them aside.
19)
Using small modeling snips or a small rotary tool cutoff wheel, remove the small
vertical plastic pieces from the plastic housing. Shown in red. Be careful to leave the
pieces not highlighted in red.
