© Qube Engineering 2009
Qube’s AP1 LED Dash DIY Kit Supplemental Instructions Page 7
9)
Carefully remove the lower trace filament
from the gauge cluster housing. You may
want to use the small flat screwdriver to
help certain parts of the filament off the
housing. Set it aside.
10)
Turn the gauge cluster face up. Remove
and set aside the rubber pads from the tabs
at the base of the gauge cluster.
11)
Undo the clips that hold the black
plastic frame onto the gauge cluster. There
is one clip on each side and four clips along
the bottom. Set the black plastic frame
aside.
12)
Lift off the clear plastic cover of the
gauge face. If it sticks to the black glass
piece, carefully pull them apart. Set the
clear piece aside.
