Installation
17
3.
Thread the wires through the base plate and screw it to the pre-drilled wall, ceiling,
CM Series Mini-Dome Recessed Mount, CM Series Mini-Dome Corner Mount, or 4S electrical
box. Check that the installation is not flimsy, will not wobble, and is flush with the mounting
surface.
4.
Plug the Cat 5 cable into the camera’s Ethernet port and, if needed, plug the power terminal
block into the power terminals.
5.
If applicable, wire the Alarm In, Alarm Out, Audio In, and Audio Out terminal blocks to
external devices. See
Camera Connections
(page 4).
6.
If needed, connect the other end of the Cat 5 cable to the network and turn on the power
from the power supply.
Note:
Do not reassemble the camera’s inner cover and mini-dome cover until after
hardware configurations and lens adjustments are made.