Configuration and Operation
63
Triggered Action
Specify one or both alarms to trigger:
Upload Image by FTP
– Selecting this option enables you to assign an FTP site and
configure various parameters, as seen in Figure 56: Trigger Action – Upload Image by FTP.
When tampering is detected, event images will be uploaded to the designated FTP site.
Note:
Images can be sent by FTP only when MJPEG is selected as the video stream
from the
Video Resolution
screen.
Specify the FTP address to use from the drop-down menu. Select the number of frames
for the pre-trigger and post-trigger buffers from the drop-down menu of 1-20 frames.
Upload Image by E-Mail
– Selecting this option enables you to assign an e-mail address
and configure various parameters, as shown in Figure 58: Triggered Action – Upload
Image by E-Mail. When tampering is detected, event images will be sent to the
designated e-mail address.
Note:
Images can be sent by e-mail only when MJPEG is selected as the video stream
from the
Video Resolution
screen.
Specify two e-mail addresses to use from the drop-down menu. Select the number of
frames for the pre-trigger and post-trigger buffers from the drop-down menu of 1-20
frames.
Note:
Make sure SMTP or FTP configuration has been completed. See section
and
FTP
for further details.
File Name
File Name
– Enter a file name in the field, for example
image.jpg.
The uploaded image’s file
name format is set in this section. Select one that meets your requirements.
Add date/time suffix (default setting)
File name: imageYYMMDD_HHNNSS_XX.jpg
Y: Year, M: Month, D: Day
H: Hour, N: Minute, S: Second
X: Sequence Number
Add sequence number suffix (no maximum value)
File name: imageXXXXXXX.jpg
X: Sequence Number
Add sequence number suffix (limited value)
File Name: imageXX.jpg
X: Sequence Number
The file name suffix ends at the number being set. For example, if the setting is up to “10,”
the file name will start from 00, end at 10, and then start over again.
Overwrite
The original image in the FTP site will be overwritten by the new uploaded file with a static
filename.
Click
Save
after configuring the settings