Quantum ValueLoader DLT VS160, Инструкция по установке и эксплуатации

Страница: 41 / 60

DLT VS160 Tape Drive Installation and Operations Guide
81-81191-01 Rev A01 January 2004 4-5
Unload/Eject Button Functions
Normal Unload/Eject
When you press and release the button, the tape drive unloads and ejects the data cartridge.
Enter Code Update Mode
When you press the button for 9 to 12 seconds, the tape drive is ready to accept a code update data
cartridge. Insert a code update data cartridge within 15 seconds to update the firmware inside the tape
drive. If you do not load a code update data cartridge within 15 seconds, the tape drive returns to
normal operating mode.
Write/Read Diagnostic Mode
When you press the button for 21 to 24 seconds, the tape drive initiates an internal write/read
diagnostic. When the diagnostic begins, the tape drive writes and then reads approximately 400 MB of
data and then unloads and ejects the data cartridge. The process takes approximately two minutes. If
the diagnostic test detects no errors, the tape drive returns to normal operating mode. If an error occurs,
the tape drive illuminates the appropriate LEDs.
Emergency Reset
When you press the button for 27 to 30 seconds, the tape drive performs a hard reset, behaving as if it
had been powered off and then on. A standard POST then occurs.
Revert to Normal Operating Mode
When you press the button for 30 or more seconds, and then release it, the tape drive returns to normal
operation.
C
AUTION
This mode overwrites all data on the data cartridge in the tape
drive. The diagnostic requires that you first load a data
cartridge that is blank or does not contain valuable data. Use
extreme caution when using this feature to avoid loss of
important data.