Quantum ValueLoader DLT VS160, Инструкция по установке и эксплуатации

Страница: 28 / 60

Chapter 3: Installing Your Tape Drive
3-12 January 2004 81-81191-01 Rev A01
Terminating Your Internal Tape Drive
If your tape drive is the only SCSI device attached to the selected server other than the SCSI host
adapter, or if it is the last physical device on the SCSI bus (at the end of the SCSI chain), you must
terminate it. If another SCSI device is the last device on the SCSI bus, confirm that it is properly
terminated and do
not terminate your tape drive.
N
OTE
: Regardless of which device terminates the SCSI bus, that device must
have power applied and be powered on for proper termination to occur.
To terminate your tape drive, install an active LVD/SE cable-end or inline terminator on the SCSI
cable you intend to use with your tape drive, as shown in
Figure 3-7 . You can use a cable-end
terminator as shown in Figure 3-7 , or an inline terminator, whichever is most convenient. See the
terminator’s instructions for more information.
Figure 3-7.
Terminator Installation
Terminator
SCSI cable