Quantum ValueLoader DLT VS160, Инструкция по установке и эксплуатации

Страница: 19 / 60

DLT VS160 Tape Drive Installation and Operations Guide
81-81191-01 Rev A01 January 2004 3-3
3.2.2 Unpacking Your Tabletop Tape Drive and Selecting a
Location
Before you begin, clear a desk or table so that you can unpack your tape drive. You also need to select
a location near the server or workstation that has room for the tape drive to sit without being crowded.
N
OTE
: If the room in which you are working differs from the temperature at
which your tape drive was shipped or stored by 30 ºF (17 ºC) or more, let
the tape drive acclimate to the surrounding environment for at least 12
hours before opening the shipping carton.
Unpacking Your Tabletop Tape Drive
Before you do anything else, unpack and inspect your DLT VS160 tabletop tape drive for shipping
damage. If you notice any damage, report it both to Quantum and to the shipping company
immediately.
N
OTE
: Save the packing materials in case you need to move or ship your tape
drive in the future. You must ship your DLT VS160 tabletop tape drive in
the original (or equivalent) packing materials or you will invalidate your
warranty.
4 Shut down and power off the server or workstation that is to host your tape drive. Page 3-5
5 Install an LVD/SE SCSI host adapter in the server or workstation, if necessary. Page 3-5
6 Connect the SCSI cable to your tape drive and SCSI host adapter. Page 3-6
7 Connect the terminator on your tape drive—if it is the last or only device on the
SCSI bus. Page 3-7
8 Connect the power cable to your tape drive, server or workstation, and all peripheral
devices. Plug the power cable into the nearest power outlet and apply power to all
devices. Page 3-8
9 Check your tape drive to make sure it is working properly. Page 3-8
Table 3-1.
Installing the DLT VS160 Tabletop Tape Drive
Step Instruction Page