Preliminary
2-10
September 21, 1999
BENCHMARK
T A P E
S Y S T E M S
Note:
If the SCSI cable that came with your SCSI host adapter already has a termintor built
into it, do not use an inline terminator. An example of such a cable is shown in Figure 2-7.
Figure 2-7: SCSI Ribbon Cable with Terminator Built-in
2.4.4 Installing your DLT1 Drive
This is the final installation stage, which requires that you install your DLT1 internal drive in
the host server or workstation and attach the SCSI and power cables.
To connect the SCSI and power cables to your DLT1 internal drive, follow these steps:
1. Shut down the operating system and turn off the selected server or workstation. Turn off
all attached accessory devices, such as printers and other SCSI devices. Remove the
power cables from the host server or workstation and all attached accessories. Failure to
follow these instructions may result in damage to your DLT1 internal drive or other
devices.
Do not move on to step 2
until you have shut down the operating system and turned
off the server or workstation that is to be the host for your DLT1 internal drive. Turn off
all attached accessory devices, such as printers and other SCSI devices. Remove the
power cables from the host server or workstation and all attached accessories.
Cable Terminator
SCSI Ribbon Cable
Supplied with SCSI
Host Adapter
