Preliminary
2-4
September 21, 1999
BENCHMARK
T A P E
S Y S T E M S
Figure 2-1: DLT1 Desktop Drive Rear Panel Layout
To set the SCSI ID on your DLT1 Desktop Drive, use a small screwdriver or ballpoint pen to
press the button above the SCSI ID display to select the next higher SCSI ID. Press the
button below the SCSI ID display to select the next lower SCSI ID. Each time you press one
of these buttons, the SCSI ID increases or decreases by one. Press the appropriate button
until the desired SCSI ID appears on the switch display.
Figure 2-2: SCSI ID Switch
2.3.3.2
When to Use Termination
If your DLT1 Desktop Drive is the only SCSI device – other than the SCSI host adapter – on
the selected server or workstation, it must be terminated. Likewise, if your DLT1 Desktop
Drive is the last device on the selected server or workstation’s SCSI bus, it must be
terminated.
To terminate your DLT1 Desktop Drive, locate the terminator in the accessories package
and press it firmly into either of the two SCSI connectors on the rear panel of the drive.
Secure the terminator by tightening the screws until snug or by snapping the wire bales into
place.
SCSI
connectors
SCSI ID
Switch
Power Switch
Power Cable
Connector
Press here to increase
SCSI ID
Press here to decrease
SCSI ID
