Qualstar RLS-8350, Техническое и сервисное руководство

Страница: 46 / 111

5-8 The Private
511010 Rev. 07-01-19
5.2.3 Theta and Y Corrections Screen
Figure 5-8 The Calibration/Theta and Y Corrections Screen
This screen shows the value of the mechanical position corrections determined during
calibration to adjust for mechanical manufacturing tolerances. The values on this
screen should only be edited by an authorized service technician.
Information on this screen may be edited by pressing the Edit button. Note that
changes to the screen will not be saved until the Save button is pressed. Pressing the
Cancel button will remove all of the current editing and revert to the last saved ver-
sion of the screen.
Section Field Description Option
Theta Correction Theta Correction Calibrated mechanical position corrections –
Y – IO Port Corrections Left IO Port Calibrated mechanical position corrections –
Right IO Port Calibrated mechanical position corrections –
Y – Drive Correction Drive Calibrated mechanical position corrections –
Y – Elevator Correction Elevator Lower Calibrated mechanical position corrections –
Elevator Upper Calibrated mechanical position corrections –
Y – Left Corrections Column A Calibrated mechanical position corrections –
Column B Calibrated mechanical position corrections –
Column C Calibrated mechanical position corrections –
Column D Calibrated mechanical position corrections –
Y – Right Corrections Column A Calibrated mechanical position corrections –
Column B Calibrated mechanical position corrections –
Column C Calibrated mechanical position corrections –
Column D Calibrated mechanical position corrections –
Table 5-3 Calibration/Theta and Y Corrections Screen Information