Page
8
AN-X2-GENI (AN-X-GENI/B)
May 2013
Quick Start
Step
See page
1
Power up the AN-X, connect it to Ethernet and assign it
an IP address
2
(Not needed for existing installations) Use the Genius
hand-held monitor to assign serial bus addresses to
Genius devices and perform any other necessary
configuration.
3
Use the AN-X web interface to set the baud rate and
serial bus address for the AN-X2-GENI
4
Connect AN-X to the Genius network
5
Use the AN-X web interface to autoconfigure the
Genius network and ControlLogix configuration
6
Configure the AN-X in RSLogix 5000
7
Use the web interface to obtain aliases for RSLogix
5000
8
Import the aliases into RSLogix 5000
9
Use the aliases to access data
