Configuration manual
10. Software Upgrade
103
www.qtech.ru
#################################################OK
Download " rp39-7.3.2.80(R).pck " (52040332 Bytes) successfully
Verify the image...valid!
Writing
file
/flash/rp39-7.3.2.80(v2.3.0.309)-debug.pck
............................OK!
backup qtos to raw flashOK!
Sysupdate image rp39-7.3.2.80(R).pck successfully.
The preceding message indicates that the QTOS file is upgraded successfully. And then reboot
the device.
If the command option reload is added, the system prompts whether to
save the configuration and whether to restart the device. However, usually
the device is started after all programs are upgraded. Therefore, the reload
option is not recommended.
Before the upgrade, ensure that there is sufficient space in the flash
memory. If the space is insufficient, the upgrade fails. In this case, you can
manually delete files that are not in need from the flash memory to obtain
more space for upgrading application programs.
It takes a long time to upgrade the image program package. A smaller
remaining space in the flash memory results in longer upgrade time.
After the upgrade is completed, to run the new image program, restart the
device.
If the device fails to start normally, enter the bootloader interface, modify
the startup mode to network startup. After the device is started
successfully, start the upgrade. For the method, refer to the related section
in the bootloader configuration manual and command manual.
During the upgrade process, the device must not be powered off or
restarted. Otherwise, the system may fail to start, or the flash file system of
the device may be damaged.
10.2.2
Upgrade the FPGA Program
Configuration Condition
Before upgrading the FPGA program, first complete the following tasks:
