Qlogic QConvergeConsole CLI 8100 Series, Руководство пользователя

Страница: 334 / 348

B–Cisco Nexus 5000 Series Switch Configuration
Enable FCoE on the Switch
B-2 FE0254601-00 A
Enable FCoE on the Switch
To enable the FCoE function on the switch:
1. Determine whether the FCoE function is enabled on the switch by issuing
the
show feature
command. In the following example, the FCoE function
is disabled.
nexusmv1# show feature
Feature Name Instance State
-------------------- -------- --------
fcsp 1 disabled
tacacs 1 disabled
fc-port-security 1 disabled
fabric-binding 1 disabled
port_track 1 disabled
npiv 1 enabled
lacp 1 disabled
npv 1 disabled
interface-vlan 1 disabled
private-vlan 1 disabled
udld 1 disabled
vpc 1 disabled
cimserver 1 disabled
fcoe 1 disabled
fex 1 enabled
If the FCoE function is already enabled, proceed to “Create and Configure
the VLAN” on page B-3 .
2. Enter the configuration mode and enable the FCoE function by issuing the
following commands:
# configure terminal
(config)# feature fcoe
nexusmv1# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
nexusmv1(config)#
feature fcoe
FC license checked out successfully
FCoE manager enabled successfully