Pycom FiPy, Руководство пользователя, Страница: 487 / 496

$ pycom-fwtool-cli list
/dev/cu.usbmodemPy343431 [Pytrack] [USB VID:PID=04D8:F013 SER=Py343434 LOCATION=20-2]
/dev/cu.Bluetooth-Incoming-Port [n/a] [n/a]
On Windows:
COM6 [Pytrack] [USB VID:PID=04D8:F013 SER=Py343434 LOCATION=20-2]
This is the only command that does not require any additional parameters.
All other commands require that the serial port is specified either through the
-p
/
--port
option or through environment variable
ESPPORT
You can optionally specify
the speed either through
-s
/
--speed
or via environment variable
ESPBAUD
. The
default speed is
921600
. The maximum speed for read operations on PIC based
expansion boards & shields is
230400
. The speed will be reduced automatically if
necessary.
Special note for Expansion Board 2.0
You will need to have a jumper wire connected between
G23
and
GND
to use any of
the commands below. You will also need to press the reset button either before
running each command or at least before running the first command. To avoid having to
press the reset button again after each command, you can use the
-c
/
--
continuation
option. The first command connecting to the device MUST NOT use the
-
c
/
--continuation
option. This is to make sure a program called
_stub_
is uploaded
onto the device. This
_stub_
cannot be uploaded more than once, so you need to tell
the cli tool that the
_stub_
is already running, which is done through using the
-c
/
--
continuation
option.
chip_id
Shows the unique ID of the ESP32 on the connected module.
usage: pycom-fwtool-cli -p PORT exit [-h]
optional arguments:
-h, --help show this help message and exit
wmac
10.2 CLI Updater
487