Pycom FiPy, Руководство пользователя, Страница: 486 / 496

pycom-fwtool-cli [global parameters] [command] [command parameters]
While
pycom-fwtool-cli -h
shows help for global parameters and a list of available
commands, command specific parameters can be viewed using
pycom-fwtool-cli
[command] -h
The parameter
-r, --reset
has been added as a courtesy for users of 3rd party
ESP32 products. This functionality is not supported by the Expansion Board 2.0 and
may cause this tool to crash or hang in certain circumstances.
Global Parameters
`-h / --help` : shows above help (you can also get detailed help for each sub-comma
nd
`-v / --verbose` : show verbose output from esptool.
`-d / --debug` : show debug output from fwtool.
`-q / --quiet` : suppress most output, used for scripting
`-p / --port` : specifies the serial port to be used. Can also be set via **environ
ment variable ESPPORT**
`-s / --speed` : specifies the serial speed to be used. Can also be set via **enviro
nment variable ESPBAUD**
`-c / --continuation` : continue previous connection in FTDI mode. This allows running
multiple commands sequentially without having to reset the module. This option is ign
ored in PIC mode as the module can be reset via the serial connection.
`-x / --noexit` : This will prevent the PIC from leaving firmware update mode.
`--ftdi` : This will force the CLI updater to run in FTDI mode.
`--pic` : This will force the CLI updater to run in PIC mode.
`-r, --reset` : This will force the CLI updater to use Espressif's workaround to sw
itch into Firmware update mode. This reset method is intended for 3rd party hardware o
nly and is not supported by the Expansion Board 2.0
Commands
list
Get list of available serial ports ports.
usage: pycom-fwtool-cli list [-h]
optional arguments:
-h, --help show this help message and exit
Example: On macOS:
10.2 CLI Updater
486