PURSUIT 2670 Denali, Руководство пользователя

Страница: 26 / 154

2670 DENALI
2.3 Neutral Safety Switch
Every control system has a neutral safety switch incorporated into it. This device prohibits the
engine from being started while the shift lever is in any position other than the neutral position.
If the engine will not start, slight movement of the shift lever may be necessary to locate the
neutral position and disengage the safety cutout switch. Control or cable adjustments may be
required to correct this condition should it persist. See your Pursuit dealer for necessary control
and cable adjustments.
The neutral safety switches should be tested periodically to ensure that they are operating
properly. To test the neutral safety switches, make sure the engines are tilted down and move
the shift levers to the forward position. Make sure the control levers are not advanced past the
idle position. Turn the ignition key to the start position just long enough to briefly engage the
starter for the engine. Do not hold the key in the start position long enough to start the engine.
The starter should not engage for either engine. Repeat this test with the shift levers in reverse
and the engine throttles at idle. Again, the starter should not engage for either engine. If the starter
for either engine engages with the shift controls in any position other than the neutral position,
then the neutral safety switch is not functioning properly and you should contact your dealer and
have the neutral safety switch repaired before using your boat. If an engine starts in gear during
this test, immediately move the control levers to the neutral position and turn the engine off.
IN SOME SITUATIONS, IT MAY BE POSSIBLE TO ACCIDENTALLY START AN EN-
GINE IN GEAR WITH THE THROTTLE ABOVE IDLE IF THE NEUTRAL SAFETY
SWITCH IS NOT OPERATING PROPERLY. THIS WOULD CAUSE THE BOAT TO
ACCELERATE UNEXPECTEDLY IN FORWARD OR REVERSE AND COULD RESULT
IN LOSS OF CONTROL, DAMAGE TO THE BOAT, OR INJURY TO PASSENGERS.
ALWAYS TEST THE NEUTRAL SAFETY SWITCH PERIODICALLY AND CORRECT
ANY PROBLEMS BEFORE USING THE BOAT.
2.4 Engine Stop Switch
All Pursuit boats rigged with outboard motors are equipped with
an engine stop switch and lanyard. When the lanyard is pulled
it will engage the switch and shut off the engines. We strongly
recommend that the lanyard be attached to the driver whenever
the engines are running. If the engines will not start, it could be
because the lanyard is not properly inserted into the stop switch.
Always make sure the lanyard is properly attached to the engine
stop switch before attempting to start the engines.
Please refer to the engine owner's manual for additional infor-
mation on the engine stop switch.
Engine Stop Switch
2-2