PURSUIT 2670 Denali, Руководство пользователя

Страница: 67 / 154

2670 DENALI
Chapter 10:
INTERIOR EQUIPMENT
10.1 Marine Head System
The marine toilet is located in a compartment aft of the V-
berth. The flush water is supplied by a thru-hull fitting
located in the equipment compartment bilge aft of the
cabin and a raw water line. Before using, open the inlet
valve on the head and pump to wet the inside of the bowl.
After use, pump to discharge the waste to the holding
tank, then close the inlet valve and pump the bowl dry.
The waste remains in the holding tank until it is pumped
out by a waste dumping station.
Holding Tank
The holding tank is located in the bilge. When the tank is full, it must be pumped out by an
approved waste dumping station through the “waste" deck fitting or the overboard macerator
discharge system.
Monitor the waste level in the holding tank and have it pumped out before it is completely full.
If the holding tank is allowed to overfill, the waste will overflow into the tank vent and then
overboard.
IN MANY AREAS IT IS ILLEGAL TO FLUSH HEAD WASTE DIRECTLY OVER-
BOARD. VIOLATION OF THESE POLLUTION LAWS CAN RESULT IN FINES OR
IMPRISONMENT. ALWAYS KNOW THE LAW FOR THE AREAS IN WHICH YOU
BOAT. NEVER DUMP HEAD OR HOLDING TANK WASTE OVERBOARD ILLE-
GALLY.
Holding Tank and Macerator Discharge Pump
When the holding tank is full it must either be pumped out by an approved waste dumping
station through the waste deck fitting or be pumped overboard with the macerator discharge
pump, when legal to do so.
To operate the macerator discharge pump, open the ball valve at the overboard discharge thru-
hull fitting located in the equipment compartment aft of the cabin bulkhead. Then activate the
macerator switch until the tank is emptied. Release the switch and close the discharge ball
valve when pumping is complete.
10-1
Marine Toilet
NOTICE