To the consumer, Guardian Technologies LLC warrants this product to be free of defects in materials
or workmanship commencing upon the date of the original purchase. Save your original sales
receipt to validate start of warranty period. Warranty is not valid without receipt.
If this product should become defective within the warranty period, we will repair or replace any
defective parts free of charge. All warranty repairs must be completed by Guardian Technologies
LLC. This warranty
does not cover unauthorized repairs.
The warranty does not include unusual
wear, damage resulting from accident, or unreasonable use of the product. This warranty only
covers the product when used with genuine Guardian Technologies accessories. This warranty
covers product that was purchased from authorized distributors. This warranty gives you specific
legal rights and you may also have other rights (other rights may vary from state to state in
the U.S.A.)
The product warranty registration can be completed online at
www.guardiantechnologies.com.
We consider the registration process important to ensuring
superior service to our customers, however submitting the warranty registration is optional and
does not affect your rights to utilize this warranty according to the conditions stated above. To
submit product under warranty the complete machine must be delivered pre-paid to Guardian
Technologies LLC. Please include complete information including: the problem, the model number
of the product, the day of purchase, and a copy of the original sales receipt along with your name,
address, and telephone (email optional). Address returns to the attention of: Customer Service,
at the address below. Additional questions or comments can be made toll free to the number
listed below.
Guardian Technologies LLC
7700 St. Clair Avenue
Mentor, Ohio 44060
1.866.603.5900
www.guardiantechnologies.com
©
2007 Guardian Technologies LLC
This product has been tested and complies with the requirements for Federal
Communications Commission, Part 18 for Radio/TV/Communication interference.
Although tested, it may affect these devices. If the humidifier is found to interfere,
separate the device and/or the humidifier. Conduct only the user maintenance found
in this manual. Other maintenance and servicing can cause harmful interference
and can void the required FCC compliance.
LIMITED WARRANTY
E-10
E-11
PROBLEM
SOLUTION
Water vapor and humidity are
not produced.
Power Plug: Unplug and then try again.
Power Failure: When the power is returned, try again.
Tank Installation: Make sure the tank is correctly attached.
The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
(see pg. E-8)
Air blows but water vapor is
not produced.
Excessive Water: Remove a certain amount of water from
the tank.
The desired humidity is lower than the current temperature:
Increase the desired humidity.
Detergent residue and/or oil ingredients from
cosmetics, etc may
be in tank; wash out tank and try again.
The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
(see pg. E-8)
If you use hard water, replace with softer water.
Humidity level is low.
The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
(see pg. E-8)
The water in the unit is too cold: Replace with cool, but not
cold water.
Damage on the ultrasonic disk: Contact Customer Service
1.866.603.5900
Warm humidity is not produced.
It may take 10-15 minutes before warm humidity is created. The
mist may not feel warm due to the fact it is so fine and is cooled
rather quickly from the air in your home. Test by either feeling the
base of the unit which should be warm to the touch or by allowing
the unit to run for approximately 30 minutes on warm setting in
a closed 200 sq. foot room or smaller. The room should feel
moderately warmer if the unit is working properly.
The humidity has a bad smell.
Poor maintenance or dirty water: Clean the product thoroughly, and
fill it with fresh water. (see pg. E-8)
White dust is forming on
nearby furniture.
Hard water may deposit a certain amount of dust. Dust in the air
also settles because of added humidity in the room. Use distilled
water if this becomes a nuisance.
* Decalcification Filter (FLTDC) available at
www.guardiantechnologies.com or through Customer Service
1.866.603.5900.
Unit has stopped working.
No or low water. Unplug unit and refill tank.
Water is accumulating outside of unit
or area surrounding unit.
Saturation of humidity. Lower mist control setting.
Unit not level and water is accumulating. Unplug and place on
level surface. Point spray away from objects. Raise unit on a
water-resistant level surface 2-3 feet off of floor.
Water dripping when refilling.
Water remaining on bottom of tank. Wipe tank or tilt to drain
before transporting.
Increased noise level.
Unit must be placed on a flat, level, hard surface. Make sure it is
NOT placed on a soft or absorbent surface.
TROUBLESHOOTING GUIDE
