Pulsar MicroFlow-i, Инструкция по эксплуатации

Страница: 33 / 56

Page 27
Chapter 4 Understanding how the MicroFlow-i operates
In order to initially set up the MicroFlow-i (if required) to obtain readings from
your application, it is advised to do this using MicroFlow-i HART PC .
Once the MicroFlow-i has been powered up, you can now begin to obtain flow
velocity from the sensor.
MicroFlow-i HART compatible
The MicroFlow-i uses a unique protocol which enables it to be compatible to any
HART controller that it is connected to, the HART address is ‘0’.
4 – 20 mA Device
The MicroFlow-i
can be used as an ‘out of the box’ 4 – 20mA device, this is the
case, by default when you switch the sensor on. The 4 – 20mA output is
proportional to the flow
velocity being seen, with respect to the maximum range
of the sensor up to 6 m/s (19.7 ft/s).
Important Information
For further information on how to set up the sensor as a mA device,
please contact your local Pulsar distributor.
To enable the MicroFlow-i to work successfully, ensure
that the power is disconnected prior to a connection being
made.