Pulsar MicroFlow-i, Инструкция по эксплуатации

Страница: 47 / 56

Page 41
Processing Parameters
These parameters relate to the detection and processing of the flow velocity signal.
Name
Parameter
No.
Options Default Notes
Gain 102 100 - 1600 120
Used to enter a fixed gain
(sensitivity) value, a higher
number means higher gain.
Quick response
Damping Factor
104 10 – 999 750
When P113=1, this damping
factor will be applied. When
P113=0, measurement will
only be damped by P109 the
main damping factor.
Cal Factor 108 1 – 500 100
In percentage terms, default
is 100, for 100%. 50%
would half and 200% would
double.
High/Main
Damping
109 0 - 28 0
This sets the damping factor
by adding to P104. A higher
number represents more
damping.
Step Response
Mode
113
0 = Off
1 = On
1
When turned off, no damping
by pass will be performed.
Low Damping
Persist
115
1 – 100
2
This is the number of
measurements that the sensor
acquires, before switching
into damping mode.
High Damping
Persist
116
1 - 100
1
This is the number of
measurements that the sensor
acquires, before switching
into Step Response Mode.
No Signal
Persist
117 1 – 100 2
This is the number of non-
measurement to persist
before the sensor sees a state
of no signal.
Signal Present
Persist
118 1 - 100 2
This is the number of
measurements that need to
persist for there to be a signal
present state.