ProSoft Technology RLXIC-EH, Руководство пользователя

Страница: 82 / 111

RLXIC-EH ♦ Intelligent Cellular Configuration Commands
RadioLinx Intelligent Cellular Ethernet Gateway for HSUPA (3G GSM) Networks User Manual
Page 82 of 111
ProSoft Technology, Inc.
May 29, 2009
ƒ
method=N : Establish a Telnet connection
ƒ
d.d.d.d= IP address to contact
ƒ
ppppp= port to contact
Examples:
ATD - Dial (establish) default connection.
ATDP192.168.13.31/2332 - Dial (establish) UDP session to 192.168.13.31, at
port 2332.
To end the connection, issue the +++ escape sequence or drop the DTR line (if
Ignore DTR S211=0 or &D2). The default connection is set in S53.
If the method, IP address, or port is omitted, the values from S53 are used. If a
telnet connection is requested (N), and the port is not supplied, port 23 will be
used instead of the value from S53.
If a domain name is specified, the "@" symbol can be used to explicitly indicate
the start of the name. For example, if ATDPHONY is issued, this will be
interpreted as dial a UDP connection to "HONY". To dial using the default
method to host "PHONY", one would issue ATD@PHONY.
Several special dialing numbers exist to make it easy to establish a PPP or SLIP
connection with the modem. ATD#19788 or ATDT#19788 will establish a PPP
connection (see \APPP) and ATDT#7547 will establish a SLIP connection (see
\ASLIP).
Tip: The source port of the session is the Device Port (set by S110 or *DPORT).
DS=n
Allows a PPP connection to be initiated on the host port.
ƒ
n=2 : Initiates the PPP connection.
Cannot be configured in AceManager.
Hn
Hang-Up Command.
ƒ
n=1 : Hang-up
With an AT telnet connection, this command will terminate the host data mode,
and return the RLXIC-EH to an AT mode. Cannot be accessed in AceManager.
O
Online (Remote): Causes the RLXIC-EH to go from Command State to data
state. Cannot be configured in AceManager.
Vn
Command Response Mode.
ƒ
n=0 : Terse (numeric) command responses
ƒ
n=1 : Verbose command responses (Default).