PRONAR T669XL, Руководство оператора, Страница: 84 / 135

Pronar T669XL, Pronar T700XL SECTION 4
4.22
DANGER
Ensure that during unloading nobody is near tipped load box or load material
pouring out.
When closing the rear grain chute gate take particular care to avoid crushing
fingers.
Rear load box wall is equipped with chute slide gate (1) – figure (4.2) and chute (2) (optional
equipment) which is used for unloading loose materials. Chute design allows very accurate
dosing of the material to packaging (sacks, boxes etc.). The opening gap can be controlled
using lever (3). In order to do that loosen the bolt interlocking slide gate (4), open the slide as
required and lock again using the bolt. During unloading through chute, load box must be
raised slowly and smoothly. Raising the load box quickly will exert large pressure on the rear
part of the load box due to displacement of the carried material and could compromise
trailer's stability.
4.6 PROPER USE AND MAINTENANCE OF TYRES
•
When working on the tyres, chocks or other objects without sharp edges should
be placed under the wheels of the trailer to prevent it from rolling. Wheel may be
taken off the trailer axle only when the trailer is not loaded.
•
Repair work on the wheels or tyres should be carried out by persons trained and
entitled to do so. This work should be carried out using appropriate tools.
•
Inspect tightness of wheel nuts after the first use of the trailer, every 2 - 3 hours
during first month of work and then every 30 hours of use (travel). The inspection
should be repeated individually if a wheel has been removed from the wheel axle.
Wheel nuts should be tightened according to recommendations provided in
section 5 MAINTENANCE.
•
Regularly check and maintain correct air pressure in tyres according to Operator's
Manual (especially if trailer is not used for a longer period).
•
Pressure and tyres should be also checked during the whole day of intensive
work. Please note that higher temperatures could raise tyre pressure by as much
as 1 bar. At high temperatures and pressure, reduce load or speed.