PRONAR T669XL, Руководство оператора, Страница: 35 / 135

SECTION 2 Pronar T669XL, Pronar T700XL
2.11
•
During welding work pay attention to flammable or fusible elements (parts of the
pneumatic, electric and hydraulic systems, plastic parts). If there is a risk that they
will catch fire or be damaged, they should be removed or covered with non-
flammable material before commencing welding work. Before beginning work,
prepare a CO or foam extinguisher.
•
In the event of work requiring the trailer to be raised, use properly certified and
technically sound hydraulic or mechanical lifts with proper lifting capacity. After
lifting the machine, stable and durable supports must also be used. Work must
not be carried out under a trailer, which has only been raised with a lift or jack.
•
The lifting jack should have sufficient lifting capacity and should be technically
reliable. The lifting jack must be positioned on a level and hard surface so as to
prevent sinking into the ground or relocating the jack during lifting. If necessary,
use proper backing plates in order to reduce unit pressure of the jack's base on
the ground and prevent its sinking into the ground.
•
The trailer must not be supported using fragile elements (bricks or concrete
blocks).
•
After completing work associated with lubrication, remove excess oil or grease.
The trailer should be kept clean and tidy.
•
Exercise caution when climbing on top of the load box. Climbing on top of the
load box is possible using ladders installed on the front wall and wall extension
and also steps attached inside the load box. Components not intended to aid
access may not be used for this purpose. Before entering load box prevent trailer
moving with parking brake and chocks.
•
Do NOT make independent repairs of control valve, brake cylinders, tipping
cylinder and braking force regulator. In the event of damage to these elements,
repair should be entrusted to authorised service point or elements should be
replaced with new ones.
•
Do NOT make repairs to drawbar (straightening, pad welding or welding). A
damaged drawbar must be replaced.
•
Do NOT install additional appliances or fittings not according to the specifications
defined by the Manufacturer.