5.3
TAB. 5.1
INFORMATION ON INSTALLATION
CONNECTION OF DRAWBAR TO THE FACEPLATE
BOLT
M24x170-8.8-B
NUT
M24-8-B
TIGHTENING TORQUE
470 Nm
WEIGHT
DRAWBAR
approx. 25 kg
The mounting height and position of the drawbar should be individually matched to tractor
hitch.
DANGER
Changing height of drawbar should be performed by two persons. Take special care
when removing the bolts because of the risk of crushing feet.
5.2
CHECKING WHEEL AXLE BEARINGS
In newly purchased sand spreader, after the first month of use or covering a distance of
100 km, while during further use – after 6 months of vehicle use check and adjust wheel axle
bearings when needed. Worn or damaged bearing should be replaced.
•
Hitch sand spreader to tractor, braking tractor with parking brake. Place
blocking chocks or other objects without sharp edges under sand spreader
wheels and raise wheels in succession using the appropriate lifting jack. The
lifting jack should be placed under the axle between U bolts fixing the axle to
the frame. Make certain that the sand spreader will not move during inspection
of the bearing.
•
Turning the wheel slowly in both directions check that movement is smooth and
that the wheel rotates without excessive resistance.
•
Turn the wheel so that it rotates very quickly, check that the bearing does not
make any unusual sounds.
Содержание T130
