PRONAR GP200, Руководство оператора

Страница: 47 / 66

SECTION 4 PRONAR GP200
4.11
4.5.2 OPERATION OF THE BRANCH CUTTING SAW
DANGER
The branch cutting saw may only be started when all guards, except the transport
protective guard, are installed and the saw is set in working position.
Before engaging the branch cutting saw drive, make sure that there are no bystanders,
especially children, near the branch cutting saw and then remove the transport
protective guard.
Other persons should be at a safe distance from the branch cutting saw during work
because of the danger that objects may be ejected (splinters, branches).
After setting the branch cutting saw in working position, the branch cutting saw drive may be
started.
HIGH NOISE LEVEL WARNING
Depending on the working conditions, the tractor (carrying vehicle) with the machine
may generate noise exceeding the level of 85dB at the driver position. In such
conditions the operator should use personal protective equipment (ear protectors).
In order to reduce the level of noise during work, the operator cab windows and door
should be closed.
When operating the branch cutting saw, pay attention to obstacles in the working area (power
lines, poles, fences, etc.). Working speed of the branch cutting saw depends on thickness of
branches, as well as the type of terrain where tractor (carrying vehicle) is moving. Travelling
speed during operation must not exceed 2 km/h.
Working speed of the branch cutting saw should be limited if:
•
thick branches are being trimmed,
•
the terrain is uneven and there are obstacles nearby,
•
there is a high risk of collision with an obstacle.
When driving across the road, pavement or other obstacles and when making turns, raise the
branch cutting saw by means of the multifunction arm and disengage the drive of the circular
saw blades.
Exercise due caution during operation. If the branch cutting saw's drive system is stopped
during operation, disengage the drive and check the cause of overload.